NerdKits - Assembler (Support Forum)

You are not logged in. [log in]

NEW: Learning electronics? Ask your questions on the new Electronics Questions & Answers site hosted by CircuitLab.

Support Forum » Assembler

NerdKits » Forums » Support Forum » Assembler (3 posts)

February 04, 2011 by dony_thomas	Hi If I want to code directly in assembler, what are the steps I need to follow to get the code into the micro-controller using the nerdkits USB cable?
February 04, 2011 by hevans (NerdKits Staff)	Hi dony_thomas, Mike gave a quick explanation of using assembly in this thread. Like Mike mentioned we tend to use inline assembly when the situation calls for some more fine grained control. Humberto
February 04, 2011 by dony_thomas	Thanks Humberto, I'll take a look.

February 04, 2011
by dony_thomas
dony_thomas's Avatar

If I want to code directly in assembler, what are the steps I need to follow to get the code into the micro-controller using the nerdkits USB cable?

February 04, 2011
by hevans
(NerdKits Staff)

Hi dony_thomas,

Mike gave a quick explanation of using assembly in this thread. Like Mike mentioned we tend to use inline assembly when the situation calls for some more fine grained control.

Humberto

February 04, 2011
by dony_thomas
dony_thomas's Avatar

Thanks Humberto, I'll take a look.

Post a Reply

Please log in to post a reply.