NerdKits - lost initial program on lcd (NerdKits Newsletter Archives)

You are not logged in. [log in]

NEW: Learning electronics? Ask your questions on the new Electronics Questions & Answers site hosted by CircuitLab.

NerdKits Newsletter Archives » lost initial program on lcd

NerdKits » Forums » NerdKits Newsletter Archives » lost initial program on lcd (2 posts)

April 19, 2012 by dexter	I lost the initial program on the lcd that had the words congradulations the hardware is ok while trying to install the new program. the lcd shows two horizontal lines instead of the original wording. also i am still having trouble installing the new program.the wiring seems correct. any suggestions ? DEXTER I.
April 19, 2012 by Ralphxyz	DEXTER I, turn the power off move the program switch down (to the right) to the RUN position turn the Nerdkit back on! You might have to also remove the USB cable (unplug from pc). You can also reload the initialload project and then run that again. Ralph

April 19, 2012
by dexter
dexter's Avatar

I lost the initial program on the lcd that had the words congradulations the hardware is ok while trying to install the new program. the lcd shows two horizontal lines instead of the original wording. also i am still having trouble installing the new program.the wiring seems correct. any suggestions ? DEXTER I.

April 19, 2012
by Ralphxyz

DEXTER I, turn the power off move the program switch down (to the right) to the RUN position turn the Nerdkit back on!

You might have to also remove the USB cable (unplug from pc).

You can also reload the initialload project and then run that again.

Ralph

Post a Reply

Please log in to post a reply.